Fault Indications; Causes And Rectification Of Faults - CASO DESIGN Steam Chef Mode D'emploi Original

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 56

15.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code
E-1/
Excessive temperature within cooking chamber
E-2
/temperature exceeded on the steam generator
The overheating cut-out terminated the current program.
The device can be re-activated after the cool down phase.
E-3
Desired temperature is not reached.
E-4
Pull the mains plug. Wait for 10 minutes. Repeat the process.
E-5
Sensor fault
E-6
The device has detected an error on a sensor and has terminated the
current programme. Pull the mains plug. Wait for 10 minutes. Repeat the
process.
E-7
Technical defect
Contact customer service.
► If error messages continue to appear after an extended waiting period and restarting
the device, then the device will need to be sent to Customer Service to be inspected.

15.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Incorrectly selected time or
power level
Please note
Description
Close device door
Plug in mains plug!
Activate fuse
Re-set time and power level
Repeat process
Action
53

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

3066

Table des Matières