Electrical Connection; Assembling The Accessories - CASO DESIGN Steam Chef Mode D'emploi Original


The device is not intended to be installed in a wall or a built-in cupboard.

Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.

The surface for placing the appliance must be at least 85 cm above the floor.

The device requires an adequate flow of air in order to operate correctly. Leave 20 cm
of free space on all sides. Do not place anything upon the appliance.

WARNING! Do not close the ventilation openings in the device housing.

Do not cover up any openings on the device and do not block these off.

The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.

The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.

11.10 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:

Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device
If in doubt, ask your qualified electrician.

The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.

Make sure that the power cable is undamaged and has not been installed under the
device or over hot or sharp surfaces.

The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.

The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.

11.11 Assembling the accessories

Water tank
Take the water tank out before the steam cooking process and fill it with drinking water or
distilled water. Reinsert the water tank correctly.
The steam cooker functions may not be operated while the water tank is empty.
43