Lenz DIGITAL PLUS SILVER 21 Mode D'emploi page 32

32
6 (5) 0
1
7 (6) 0
1
8 (7) 0
1
51 Bit Braking configuration
1 (0) 1
2 (1) 1
3 (2) 1
4 (3) 1
5 (4) 1
6 (5) 1
7–8 (6-7) Not used
0-255 Braking distance with activated constant braking distance
52
0-255 Slow approach with ABC
53
0-255 Stopping time in push-pull operation, 1 to 256 sec
54
55 0-255 Sets brightness at function outputs A and C, 255=max
56 0-255 Sets brightness at function outputs B and D, 255=max
Function mapping:
57
Each bit of the CV stands for a function of the digital system:
-
Bit 1(0) for function 1, Bit 2(1) for function 2 and so on up to
59
Bit 8(7) for function 8. If you wish to allocate a function to the
EMF switch inactive
EMF switch active
Control switched on
Control switched off
High-frequency motor control (approx. 23 kHz)
Low-frequency motor control (approx. 19 Hz)
Constant braking distance activated
ABC activated
ABC direction-dependency deactivated
Activate push-pull operation without intermediate stop
Activate push-pull operation with intermediate stop
Stopping with DC independent of the polarity (only if Bit 3 is
deleted in CV29).
Information SILVER 21 Decoder
0
0
0
0 (dec)
0
0
0
0
0
0
0
50
48
4
255
255