Hitachi SP 18V Mode D'emploi page 6

English
PRECAUTIONS ON USING ELECTRONIC
SANDER POLISHER
1. Never mount a grinding wheel and attempt to use
this tool as a disc grinder.
SPECIFICATIONS
Voltage (by areas)*
Power input
No load speed
Sanding Disc Size outer dia. × inner dia.
Weight (without cord, standard accessories)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) 180mm Sanding Disc ............................................... 5
(Grain: P24, P30, P50, P80, P120 ................ 1 each)
(2) Rubber Pad ................................................................ 1
(3) 180mm Wool Bonnet ............................................... 1
(4) Wrench ....................................................................... 1
(5) Side Handle ............................................................... 1
Standard accessories are subject to change without
notice.
APPLICATIONS
Grinding metal surfaces
Preliminary sanding of metal surfaces before paint-
ing, rust removal, removing old paint before repaint-
ing.
Finishing woodwork, correcting projections of tim-
ber from joints or assemblies.
Preliminary sanding of wood surfaces before apply-
ing paint.
Polishing or shining painted metal surfaces, such as
those of automobiles, trains, elevators, refrigerators,
sewing machines, washing machines, metal appli-
ances, etc.
Polishing varnished surfaces of wooden furniture,
etc.
Shining synthetic resin or ebonite products.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized con-
forms to the power requirements specified on the
product nameplate.
CAUTION
Do not operate on Direct Current power source.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
4
2. Always hold the body handle and side handle of
the power tool firmly
Otherwise the counterforce produced may result in
inaccurate and even dangerous operation.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
1100W*
1400 – 3400/min
180 × 22mm
3.0kg
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Confirm the lock pin
Confirm that the lock pin is disengaged by pushing
the lock pin two or three times before switching the
power tool on. (See Fig.3, 4)
5. Fixing the side handle
Screw the side handle into the gear cover.
PRACTICAL ELECTRONIC SANDER POLISHER
APPLICATIONS
Motor speed can be variable as desired by rotating the
dial; it is increased by turning the dial towards "E",
decreased by turning it towards "A" (Fig.1).
Select the motor speed appropriate for the work being
done. The following table gives the motor speeds
corresponding to each indication on the dial scale and
shows the types of work for which they are suitable.
Dial R.P.M.
Indication
A 1400
B 1900
C 2400
D 2900
E 3400
CAUTION
The dial cannot be rotated further than the "E" or "A" on
the scale in their respective directions.
Type of work
}
For Polishing
}
For Sanding