Carrier KC Serie Guide Du Propriétaire page 5

6. A piece of thin foam sealing is provided. Cut piece
to fit across the bottom of the window sash. See
Fig. 5. After the foam seal has been cut, remove
the peel-off backing and stick to bottom of
window.
7. Measure the width of the inside sill of the window
and mark the center of the sill. See Fig. 6. Mea-
sure 7 1 / -in. from the center on both sides and
2
mark on window sill. Mount the two L-brackets on
the window sill with a
Fig. 7. The L-brackets will hold the bottom chan-
nel of the air conditioner cabinet in the correct
position when installed. Check that brackets are
in the correct position before installing.
8. Place air conditioner in the window. The bottom
channel of the air conditioner should be between
the window sill and the L-brackets. Lower the
window sash until it rests firmly behind the upper
channel. Make sure the top and bottom of the cab-
inet fits snugly to the window opening. See Fig. 8.
9. Secure the air conditioner to the window sill. See
Fig. 9. Remove the 3
each side of the air conditioner. Install side brack-
ets (provided) on each side of the air conditioner
using the screws that were just removed. Leave
screws loose. Mount side brackets onto the win-
dow sill next to the air conditioner using two
/ -in. screws (provided) for each bracket. Tighten
3
4
/ -in. screws to secure brackets to air conditioner.
3
8
10. Secure the air conditioner to the bottom of the
window sash with one
Screw is installed through the hole in the center of
the top channel of the air conditioner. See Fig. 9.
TOP CHANNEL
SIDE SHUTTER
INSTALLATION
SCREWS
BOTTOM
CHANNEL
FIGURE 4 — SIDE SHUTTER INSTALLATION
3 / -in. screw (provided). See
4
/ -in. screw from the bottom of
8
/ -in. screw provided.
3
4
FIGURE 5 — FOAM SEAL INSTALLATION
FIGURE 6 — DETERMINE CENTER OF SILL
3/4"
SCREW
OUTER SILL
BRACKET
SHORT SIDE
FIGURE 7 — L-BRACKET INSTALLATION
L BRACKET
FIGURE 8 — AIR CONDITIONER
INSTALLATION LOCATION
5
SEAL
CENTER LINE
INNER SILL
CENTER LINE
3/4"
SCREW
SEAL