Festo SPC200-COM-DN2 Guide Rapide page 21

4 Instructions on commissioning
Caution
Injury to people and damage to property!
Make sure that nobody can place his/her hand in the
positioning range of the moveable mass and that there
are no objects in its path.
Use WinPISA for the field bus configuration of the SPC200.
Configuration by a master is not possible.
1. Opening or creating a project.
2. Insert SPC200 hardware.
3. Configure the SPC200 (define modules).
4. Select field bus card:
5. Define the operating mode of the SPC200.
6. Configure the field bus card
7. If necessary, undertake I/O assignment (IO mapping).
8. Confirm settings with OK.
9. Load the project completely into the SPC200.
Festo SPC200−COM−DN2 0602a English
SPC200−COM−DN2: DeviceNet2
SPC200−COM−CAN: CANbus or DeviceNet
Start/Stop or
Record Selection
Select protocol variant (only SPC200−COM−DN2)
Define bus address
Define baud rate
Configure I/O ranges (see next page)
21