1
User
The field bus module type SPC200−COM−DN2 or ...−CAN
enables the SPC200 to be coupled as a slave to a
DeviceNet scanner. For commissioning an SPC200 with
field bus module you will require the WinPISA software.
Versions
SPC200−COM−CAN
SPC200−COM−DN2
Detailed information on the field bus module can be found
in the manual P.BE−SPC200−COM−CANDN−...
Caution
You must observe the:
safety precautions and the
designated use of the relevant components and
modules.
Warning
Actuators can be activated unintentionally and the
SPC200 can be damaged if modules are fitted or
removed when the power supply is still switched on.
Before carrying out installation and/or maintenance
work, switch off the following sources of energy in the
sequence specified:
1. the compressed air supply
2. the load and operating voltage supply.
Festo SPC200−COM−DN2 0602a English
instructionsEnglish
1.0
1.2
2.01
WinPISA
SPC200 firmware
4.1
3.8
4.31
4.63
4.5
4.9
15