Carson BL 1 BRUSHLESS SET Mode D'emploi page 6

Normal startup procedure:
1. Switch on transmitter, move throttle stick to bottom.
2. Connect battery pack to ESC, special tone like "1,2,3" means power supply is OK.
3. Several "beep-" tones should be emitted, presenting the quantity of lithium battery cells.
4. When self-test is finished, a long "beep- - - - - " tone should be emitted.
5. Ready to go flying now.
Throttle range setting: (Throttle range should be reset when a new transmitter is being used)
1. Switch on transmit ter, move throttle stick to top.
2. Connect battery pack to ESC, and wait for about 2 seconds
3. "Beep-beep- " tone should be emitted, means throttle range highest point has been correctly confirmed.
4. Move throttle stick to the bottom, several "beep-" tonesshould be emitted, presenting the quantity of battery cells
5. A long "Beep-" tone should be emitted, means throttle range lowest point has been correctly confirmed
Program ESC with transmitter (4 Steps):
1. Enter program mode.
2. Select programmable items.
3. Set item value (Programmable value).
4. Exit program mode.
1. Enter program mode
1) Switch on transmitter, move throttle stick to top
position, connect the battery pack to ESC
2) Wait for 2 seconds, the motor should emit
special tone like "beep-beep-"
3) Wait for another 5 seconds, special tone like
"beep..... " should be emitted, which means
Program mode is entered
3. Set item value (Programmable value):
You will hear several tones in loop. Set the value matching to a tone by
moving throttle stick to top when you hear the tone, then a special tone " "
emits, means the value is set and saved. (Keeping the throttle stick at top
position, you will go back to step 2 and select other items; Moving the stick to
bottom within 2 seconds, you will exit the program mode directly)
Brake
Battery type
Cutoff mode
Cutoff threshold Low
Startup mode
Timing
DETAIL SETUP MENU
Off On
Li-ion/ Li-Poly NiMh/ Nicd
Reduce power Shut down
Medium
Normal Soft
Low Medium
2. Select programmable items:
After entering program mode, you can hear 8 tones in a
loop in the following sequence. If you move the throttle
stick to bottom within 3 seconds after one kind of tones,
then this item will be selected.
1. "beep" brake (1 short tone)
2. "beep-beep-" battery type (2 short tone)
3. "beep-beep-beep-" cutoff mode (3 short tone)
4. "beep-beep-beep-beep-" cutoff threshold (4 short
tone)
5. "beep-----" startup mode (1 long tone)
6. "beep-----beep-" timing (1 long 1 short)
7. "beep-----beep-beep-" set all to default (1 long 2
short)
8. "beep-----beep-----" exi t (2 long tone)
Remark: 1 long "beep-----" = 5 short "beep-"
.
High
Super soft
High
5
4. Exit program mode
There are 2 ways to exit
program mode:
1.
In step 3, after special
tone "peep" , move
throttle stick to bottom
within 2 seconds.
2.
In step 2, after tone
"Beep-----beep-----", move
throttle stick to bottom
within 3 seconds.