Dexter 350OS2.5 Manuel D'instructions page 176

FR
7. MAINTENANCE
ES
PT
IT
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
EL
If the carbon brushes need to be replaced, have this done by a quali ed repair person
(always replace the two brushes at the same time).
PL
RU
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
KZ
damage from various types of commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
UA
Lubrication
RO
All the bearings in this tool are lubricated with a su cient amount of high grade lubricant
for the life of the unit under normal operating conditions, therefore no further lubrication is
EN
required.
8. TROUBLE SHOOTING
Suspected malfunctions are often due to causes that the users can x themselves. Therefore
check the product using this section. In most cases the problem can be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly quali ed
specialist if you cannot solve the problem yourself!
176
Always disconnect the device before performing any adjustment or mainte-
nance operation. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent in order to avoid a hazard.