Optional Manual Membrane Pump; Installing The Control - Zehnder Pumpen KOMPAKTBOY 1.1 W 230 V Mode D'emploi

5.7 Optional manual membrane pump

At the collecting tank near the ground, there are 2 threaded sockets Rp 1 ½". The threaded
sockets are closed with red protective plugs. In order to connect a pipeline there, the tank
must be opened using a drill or hole saw.
i
should be installed in the venting line near the ground.

5.8 Installing the control

All electrical systems used must comply with the standard IEC 364 / VDE 0100, that
is sockets, for example, must have earth terminals.
pertinent VDE regulation 0100 must be observed!
a highly sensitive FI protected switch IA <30 mA before the control, or to prevent a
failure of the control when the FI protected switch trips, one FI protected switch per
pump has to be installed between the control and pump. For installations in bath-
rooms and showers, the corresponding regulations of DIN VDE 0100 Part 701 have
to be observed.
Please observe the regulations of EN 12 056-4.
For AC power connection, external protection has to be carried out with circuit break-
ers of characteristic K, generally 3-pole mechanically locked. In this way, complete
supply isolation is ensured and 2-phase run excluded.
In dry rooms, all electrical devices such as controls, alarm transmitters and sockets
Before every installation and disassembly of the pump or other work on the plant, it
must be disconnected from the mains supply.
The motor can overheat due to overload. In case of overheating, never touch the hot
surfaces on the motor.
When using an extension cable, it must meet the quality of the supplied connecting
cable.
Kompaktboy Double
1. Screw out the protective plug.
2. Using a drill or hole saw, drill out the closed
socket bottom (max
3. Connect the draining line.
en English
40 mm).
81