Zibro S1731 Manuel D'utilisation page 35

man_S17xx.qxd 12-03-2009
Cancelling "OFF Timer"
Press the timer fixing button "OFF". The timer lamp of the indoor unit goes off.
"SLEEP Timer"
Pressing this button starts the timer mode that will stop the operation after the setting time.
Sleep Timer features
Emergency and test operation
Emergency Operation
• The emergency operation is needed only when the remote control can not be used.
• When you press the Emergency Operation Switch, you will hear a beep and the emergency operation
starts.
• Emergency operation is preset for the following two modes, only based on the temperature of the
room at the time of operation.
Temperature
Above 23°C
Below 23°C
12:33 Pagina 35
Press the "SLEEP" button during the operation.
The setting time repeats the following mode by pressing the button:
Continuous operation (Sleep Operation: OFF). The operation stops after passing
the setting time.
NOTE
• When you select both "OFF Timer" operation and "Sleep Timer"
operation, the latest setting precedes the first setting.
• "Sleep Timer" operation has no need to set the present time.
During Cooling Operation
The setting temperature rises 0.6°C after 30 minutes of Sleep Timer ON, and rises
0.6°C again after 30 minutes of the first temperature rise.
During Heating Operation
The setting temperature drops 0.6°C after 30 minutes of Sleep Timer ON, and
drops 0.6°C again after 30 minutes of the first temperature drop.
Operation Designated
mode temperature
Cooling 26°C
Heating 23°C
Timer mode Air flow
Continuous Automatic
Continuous Automatic
4
35