Quick Start-Up - aqua Simpool Manuel D'instructions Et D'entretien

Simpool Timer Model
Programmable digital peristaltic pump
From the home page, with the F key, it is possible to display the current day of the week "dAy";
From the current day of the week, with the F key it is possible to go back to the first entry: if the display shows the
dosage countdown, this is preceded by the Dosage State tag "d.St", but, if the display shows the current time, it will
be preceded by the tag "tln".
From any entry of the Initial Menu you can go to the:
▪
Programming Menu
▪
User Menu by pressing the F key for 3 seconds;
User Menu
The User Menu allows to set the main pump dosing parameters.
You can browse through the User Menu with the F key and display:
▪
Prl: allows to prime the pump without using the switch. You can start or stop the priming with the Enter
key. The display shows a flashing "Prl" and the pump starts running at top speed.
▪
do.C: it allows to programme the weekly dosage calendar; it is possible to display the days of the week by
pressing the Enter key for 3 seconds (Sun/Mon/Tue/Wed/Thur/Fri/Sat), or ALL in case of daily planning
and it will possible to programme and display all 8 dosages, their time ad length (see
- H.d.1-d.8: in order to select/display the corresponding dosage starting hour d.1- d.8;
- n.d.1-d.8: in order to select/display the corresponding dosage starting minutes d.1- d.8;
- t.d.1-d.8: in order to select/display the corresponding dosage length in minutes d.1- d.8;
Weekly or daily dosage programming calendar parameters can be changed only after being enabled using the
Settings Menu, i.e., if the OnL (online modification) is enabled: failing that they can only be displayed.
From the User Menu you can go back to the Initial Menu by pressing the F key for 3 seconds.
Programming Menu
The Programming Menu allows to set all of the pump operating parameters and can be accessed only by entering
the password.
The Programming Menu can be accessed only using the Initial Menu: after pressing Enter for 3 seconds, the
display shows "PAS", the LED turns orange and is steady. Then press Enter again and on the password selection
menu the first digit of "000" starts flashing. With the ▲ and ▼ keys you can increase/decrease the value displayed,
with Enter you can scroll and select the desired digit. After setting the correct password, press Enter again for 3
seconds.
From every menu you will go back to the first entry of the Initial Menu if no operation is carried out for more than 2
minutes.
3.2

QUICK START-UP

This section features the steps to carry out to use the pump straight away. For further details on operation, refer to
section 3.3 "Advanced Programming".
For pump correct operation, simply set the dosage calendar, which can be accessed from the User Menu.
From the User Menu you can proceed quickly with the steps below:
▪
Prime the pump;
▪
Set weekly and daily dosages;
Here below are the pump default parameters:
▪
On-line Change of User Menu values enabled;
▪
Inactive dosages;
USER MENU
ADSP7000722
by pressing for 3 seconds;
Enter
rev. 1.0
INSTRUCTION AND MAINTENANCE MANUAL
23/02/2017
ENGLISH
Quick Start-up):
43/64