Clearing Blockages; Residual Risks - Ryobi RLM36X46H5P Traduction De La Notice Originale

materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
batteries that are cracked or leaking. Check
with the forwarding company for further
advice.
WARNING
Use extreme caution when lifting or tilting
the product for maintenance, cleaning,
storage, or transportation. The blade is
sharp; keep all body parts away from the
blade while it is exposed.
MAINTENANCE
WARNING
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
WARNING
Servicing requires
knowledge and should be performed only
by a qualifi ed service technician. Have the
product serviced by and authorised service
centre only. When servicing, use only
original replacement parts.
■
Turn off the product, and remove the
isolator key and the battery. Make sure that
all moving parts have come to a complete
stop before any cleaning or maintenance
task.
■
You may make adjustments and repairs
described in this manual. For other repairs,
contact an authorised service centre.
■
Replace worn or damaged part for safety.
■
Check the grass catcher frequently for
wear or deterioration.
■
After each use, clean the product with a
soft, dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorised service centre.
■
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure the
product is in safe working condition.
manufacturer's
accessories and
extreme care and
■
Be careful during adjustment of the product
to prevent entrapment of the fingers
between moving blades and fixed parts of
the product.
■
When servicing the blades, be aware that
even though the power source is turned off,
the blades can still be moved.
■
The blade on the product is sharp. Use
extreme caution, and wear heavy-duty
gloves when fitting, replacing, cleaning, or
checking bolt security.
■
Replace damaged blades and bolts in sets
to preserve balance.
■
The blade bolts must be adequately
tightened. See
recommendations for blade bolt torque
which can be found in the product
specification table in this manual.

CLEARING BLOCKAGES

■
Turn off the product, remove the isolator
key and the battery. Make sure that all
moving parts have come to a complete
stop.
■
Always wear heavy-duty gloves when
checking or clearing a blockage.
■
The blades are sharp and the blockage
itself could be a sharp object.
■
Remove the grass catcher, check for and
carefully clear obstructions.
■
Check the grass discharge chute, and
carefully clear blockages.
■
Turn the product on its side. Check its
underside, and the area around the
blade. If any blockages are found, remove
carefully. Remember, the blade may move
during cleaning.

RESIDUAL RISKS

Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise during use and the
operator should pay special attention to avoid
the following:
■
injury caused by vibration
●
Always use the right tool for the job. Use
designated handles and restrict working
time and exposure.
■
injury caused by noise
the manufacturer's
English | 5
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR