Installing The Power Cord - Invacare HomeFill II IOH200AW Manuel De L'opérateur

SECTION 2—INITIAL SETUP
Compressor Transportation
NOTE: For this procedure, refer to FIGURE 2.1.
NEVER transport a compressor with a cylinder connected
to or stored on the compressor as this may result in injury
or damage.
When transporting the compressor, take care no to bump
the compressor or the connectors into obstacles.
Otherwise, damage to the compressor may occur.
NOTE: For this procedure, refer to FIGURE 2.1.
1. There are two
methods for the safe
transportation of the
compressor:
A. One hand - Hold the
hand grip at the
bottom rear of the
compressor.
B. Both hands - Hold the
hand grips on the
sides of compressor.

Installing the Power Cord

NOTE: For this procedure, refer to FIGURE 2.2 on page 17.
1. Ensure the compressor is on a hard flat stable surface, such
as a table or Ready Rack.
2. Make sure the power switch is in the Off (O) position.
3. Plug the power cord into the electric connector in the back
of the compressor.
HomeFill II Compressor
®
WARNING
CAUTION
Hand Grip
Hand Grip
FIGURE 2.1 Compressor
16
Hand Grip
Transportation
Part No 1145804