Transport - Handling And Storage; Installation - RHOSS TCAEBY 269 Mode D'emploi

EN

TRANSPORT - HANDLING AND STORAGE

!
DANGER!
The unit must be transported and handled by skilled personnel trained to carry
out this type of work.
IMPORTANT!
Be careful to prevent damage by accidental collision.
Packaging components
!
DANGER!
Do not open or tamper with the packaging before installation. Do not leave the
packaging within reach of children.
SAFEGUARD THE ENVIRONMENT
Dispose of the packaging materials in compliance with the national or local legi-
slation in force in your country.
Each unit is supplied complete with:
installation and use instruction
Electronic control manual
wiring diagram
list of authorised service centres
warranty document
Lifting and handling instructions
IMPORTANT!
The unit was not designed to be lifted with a forklift truck.
!
DANGER!
Lifting the unit with the centre of gravity as off-centre could cause sudden and
hazardous movements.
!
DANGER!
Movement of the unit must be performed with care, in order to avoid damage to
the external structure and to the internal mechanical and electrical components.
Also make sure that there are no obstacles or people along the route, in order to
prevent the risk of impact, crushing or tipping the lifting and handling device.
checked their suitability (as regards their strength and state of wear
and tear). Pull the straps tight, checking that they remain properly
attached to the lifting-hook; lift the unit a few centimetres, then, only
after checking the stability of the load, carefully carry the unit to the
not to interpose body parts one handling in order to eliminate any
possible risk of crushing or any other injury if the load drops or shifts
suddenly.
Section II :: Installation and maintenance
60
Storage conditions
The units cannot be stacked. The temperature limits for storage are -9
÷ 50°C.

INSTALLATION

!
DANGER! Installation must only be carried out by skilled technicians, qua-
tion could cause the unit to run badly, with a consequent deterioration in perfor-
mance.
!
DANGER!
The unit must be installed according to national or local standards in force at the
time of installation.
!
DANGER!
The machine is designed for outdoor installation. Segregate the unit if installed
in areas accessible to persons under 14 years of age.
DANGER!
Some internal parts of the unit may cause cuts. Use suitable personal protective
equipment.
!
DANGER!
When the outdoor temperature is around zero, the water normally produced
installation area slippery.
If the unit is not secured on the anti-vibration mountings (SAG or SAM),
The unit cannot be installed on brackets or shelving.
The installation site should be chosen in accordance with the provisions
of Standard EN 378-1 and in keeping with the requirements of Standard
EN 378-3. When selecting the installation site, risks posed by accidental
refrigerant leakage from the unit should also be taken into consideration.
Outdoor Installation
Machines designed for outdoor installation must be positioned so as to
avoid any refrigerant gas leakage entering the building and posing a
hazard to people's health. If the unit is installed on terraces or building
roofs, adequate safety measures must be taken in order to ensure that
any gas leaks cannot enter the building through ventilation systems,
doors or similar openings. In the event that the unit is installed inside a
walled-in structure (usually for aesthetic reasons), these structures must
be suitably ventilated in order to prevent the formation of dangerous
concentrations of refrigerant gas.
Clearance and positioning
IMPORTANT!
Before installing the unit, check the noise limits allowed in the place where it will
be used.
IMPORTANT!
The unit should be positioned to comply with the minimum recommended clea-
rances, bearing in mind the access to water and electrical connections.
IMPORTANT!
If clearance distances are not maintained at installation, it could cause
malfunctioning with an increase in absorbed power and a considerable reduction
in cooling capacity.
The unit is designed for outdoor installation. The unit should be correctly
levelled and positioned on a supporting surface capable of sustaining
its full weight. It must not be installed on brackets or shelves.
-