Maintenance And Safety; Replacing The Belt; Replacing The Light; Replacing The Fuses - Errebi DAKAR Notice D'utilisation

4

Maintenance and safety

When carrying out maintenance operations, the following
requirements must be met:
Never carry out maintenance operations with the
1
machine in operation.
2 Unplug the machine.
3 Strictly follow the indications in the manual.
4 Use original spare parts

4.1 REPLACING THE BELT

To check the tightness of the belt or to replace, proceed as
follows:
Turn off the machine at the main switch and unplug it.
1
2 Undo the four screws securing the machine's rear protection.
Undo the four screws holding the motor in place.
3
Tighten or replace the belt.
4
To tighten the belt, push the motor towards the rear of the
machine and tighten the four screws securing the motor.
5
To replace the belt, carry out the same operations as
6
for tightening but with a new belt.

4.2 REPLACING THE LIGHT

To replace the light, proceed as follows:
Switch off the machine.
1
Release the fixing ring.
2
Remove the light and undo its wire.
3
Connect a new light to the wire, put it in its housing
4
and secure with the fixing ring.
4.3 REPLACING FUSES
If the machine does not start when switched on, check
the fuses:
To do this, proceed as follows:
1
Switch off and unplug the machine.
Remove the fuse-holder next to the main switch.
2
Check (using a tester) if a fuse has blown and, if so,
3
replace it with another identical one.

4.4 SAFETY RECOMMENDATIONS

1 Do not try to start the machine or use it until all safety
aspects, installations instructions, operating guidelines
and maintenance procedures have been carried out and
understood.
2
Always unplug the machine before carrying out
maintenance or cleaning operations.
3 Always keep the machine and its surrounding area clean.
5
Accessories
A series of accessories are available.
The machine is supplied with a series of accessories for its use
and maintenance:
Two fuses, two 3 and 2.5 Allen keys, two plates for end stop,
two F-1 / F-13 milling cutters and two P-1 / P-13 tracer points.
5.2 LIST OF ACCESSORIES FOR CUTTING
List of accessories:
Milling cutters and tracer points to be used to cut the
following keys:
See figure 23
See figure 24
ENGLISH
5.1 BASIC ACCOSSORIES
CERTAIN MODELS OF KEYS
See figure 25
13
<<<
<<<