Maintenance And Safety; Replacing The Belt; Replacing The Light; Replacing The Fuses - Errebi DAKAR-EXPRESS Notice D'utilisation

4

Maintenance and safety

When carrying out any maintenance operations, the
following requirements must be met:
Never carry out any operation with the machine switched
1
on.
Unplug the machine.
2
3 The indications in this manual must be strictly adhered to.
4
Use original spare parts.

4.1 REPLACING THE BELT

To check the tension of the belt or to replace it, proceed
as follows:
Switch off the machine using the main switch and unplug it.
1
Undo the four screws holding the machine's rear
2
protection in place.
Undo the four screws (T) securing the motor.
3
Tighten or replace the belt (C).
4
To tighten the belt, push the motor towards the back
5
of the machine and tighten the four screws (T) securing
the motor.
To replace the belt, carry out the same operations as for
6
tightening but with a new belt.

4.2 REPLACING THE LIGHT

To replace the lamp, proceed as follows:
Switch off the machine using the main switch.
1
Remove the fixing ring (A).
2
Remove the lamp and undo the wire.
3
Connect the new lamp to the wire, put it into its housing
4
and secure with the fixing ring.
4.3 REPLACING FUSES
If the machine does not start up when the switches are
turned on, check the fuses.
This can be done in the following way:
1 Switch off the machine using the main switch and unplug it.
Remove the fuseholder that can be found next to the
2
main switch.
Use a tester to check if a fuse has blown and if so,
3
replace with another fuse of the same type.

4.4 SAFETY RECOMMENDATIONS

1 Do not try and start or handle the machine until all
safety matters, installation instructions, operators guides
and maintenance procedures have been fulfilled and
understood.
2
Always switch off the power supply before carrying out
any cleaning or maintenance operations.
3 Always keep the machine, as well as its surroundings
clean.
5
Accessories
To work properly, the machine has a series of
accessories.
The machine comes with a series of accessories for use
and maintenance:
Two fuses, two Ø7X70 rods, two 3 and 2.5 allen keys,
two plates for the tips to butt up against, F-1 / F-13
milling cutter and P-1 tracer point.
5.2 LIST OF ACCESSORIES FOR CUTTING
List of accessories:
Milling cutters and tracer points to use for cutting keys:
See figure 20
See figure 21
ENGLISH
5.1 BASIC ACCOSSORIES
CERTAIN MODELS OF KEYS
See figure 22
13
<<<
<<<