PCWork PCW02A Mode D'emploi page 15

WARNING:
•
Do not measure voltage above DC 1000V or AC 750V; otherwise the
instrument might get damaged.
•
If the display shows "OL", disconnect the probes' tips from the measuring
circuit immediately (Overload)
•
Never measure voltage if probes are in current measurement sockets. This
could result in electric shock for the user and damage the device.
•
Pay special attention to safety when measuring high voltage to avoid electric
shock or personal injury.
•
Always test known voltage before using the device, in order to ensure that
the device functions properly.
•
Do not touch the bare tips of the probes; when measuring is finished, always
remove the probes from the measuring object and the device.
Note: When the measured voltage is greater than 80V, the orange backlight will
light up.
15