Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Turn on/off
3.2.2 Press
to turn on the flame effect, turn off flame effect and heater
when in normal mode.
3.2.3 Press
to turn on/off the flame effect under daily and weekly timer
mode.
Flame Effect
3.2.4 Press
to enter the flame effect adjustment screen.
3.2.5 Press the '←' and '→' button to select the 3 kinds of flame effect.
3.2.6 Press the '+' and '-' button to select the 5 brightness of flame effect and OFF
settings.
Mood Light
3.2.7
Press
to enter the mood light adjustment screen.
3.2.8 Press the '←' and '→' button to cycle through the 13 colours of mood
light or a colour-cycle mode.
3.2.9 Press the '+' and '-' button to select the 5 brightness of mood light and OFF
settings.
Normal Mode
3.2.10 Normal control mode is factory set. If it is not, then press
the logo
shows up at the upper right corner of the screen.
3.2.11 Press the '+' and '-' button to adjust the setting temperature from 17℃ to
25℃ by 2 intervals.
3.2.12 Press
button to turn on/off heat,
lower of the screen.
NOTE: It is normal for the fan heater to stop running for periods of time. This
happens because the room temperature is at or above the temperature set on the
remote control. The heater indicator will be turned off after 10s if you have the
flame ON. The heater indicator will stay ON if you use the heating function only.
Count Down Timer
NOTE: This setting is only for normal mode. It
after a set period of time.
3.2.13 Press
to cycle through the settings from Off and 0.5 hours to 9 hours.
The timer logo and time will show on the screen. The heater must be in the
ON position.
The heater can be automatically run by using daily timer and weekly timer on the
remote.
button until
ON、 OFF will show at the
allows the appliance to go into standby
20
Publicité
Table des Matières
