livin flame Nottingham Manuel De Montage Et Mode D'emploi page 19

NOTE: The manual button controls basic functions, not a full range of controls. Use the remote hand set to
carry out all functions. The manual buttons are located at the lower right corner of the appliance.
Press "LIGHTS ON/OFF" to turn on or turn off both the flame and mood light at the same time.
Press "FLAME" button to select the colour of flame (3 kinds) or return to the OFF position.
Press "MOOD LIGHT" button to select the colour of mood light (13 kinds), colour-cycle mode or return to the
OFF position.
Note: The controls on appliance will lose the memory for all function settings when the switch is set to the
Off Position. When the remote runs out of power or when you change the batteries, only the flame
function will lose memory and will not affect the timer settings, however, the clock may need adjusting.
3.2 Operating by Remote Handset
Make sure the battery are installed properly in the remote control.、

The effective range of the remote control is up to 4 meters or 13 feet.

NOTE: This is thermostatic remote control. The remote should be in the same room as fireplace and placed
on a flat surface. It must be placed away from the fire so the hot air will not blow on it and affect
thermostatic reading.
The communication frequency between the fire and remote has already been set
up. If you cannot use the remote with the fire, please follow instructions Step
3.2.34 to initiate this connection in point.
Standby for Remote Handset
3.2.1 The screen shown to the right is when the remote handset is in
standby condition.
19