Triton 2000 Serie Instructions D'assemblage Et D'utilisation page 2

GB
ONTENTS
Wheel
A
Wheel Bush
B
Locking Lever
C
U-Bracket
D
Side Plate
E
M6 x 45 Hex Bolt
F
M6 x 50 Hex Bolt
G
H
M6 x 16 Hex Bolt
I
M6 Nyloc Nut
J
M6 Washer
SSEMBLY
here are two wheel mounting holes in
ach leg of the Series 2000 Workcentre.
We recommend the wheels be fitted to the
ar pair of legs, as they are less likely to
et in your way when working.
he nuts supplied are Nyloc self-locking
uts and are vibration-proof. Tighten them
the point that the components are firmly
eld, yet still free to pivot or spin.
tep 1 (Fig. 1)
ttach the Side Plates (E) to the lower
ounting holes as shown. Use the M6 x
5 Bolts (F), washers (J), and Nyloc nuts
).
ote: the bolts pass through the rounder
nds of the plates, and the reinforcing ribs
ulge towards one another.
tep 2 (Fig. 1)
asten the Locking Levers (C) to the U-
rackets (D) using the M6 x 16 Hex Bolts
H) and nuts.
tep 3 (Fig. 1)
sert the Wheel Bushes (B) into the
bor of each Wheel (A).
Series 2000 Wheel Kit
Step 4 (Fig. 2)
Bolt the end of each locking lever to the
2
top hole in each leg using bolts (F),
2
washers and nuts.
2
Step 5 (Fig. 2)
2
Place the wheel between the side plates,
4
and fit the U-bracket over the top. Fasten
4
each wheel into position using the longer
2
bolts (G) and nuts.
2
OPERATING THE WHEELS
8
To engage the wheels, lift the leg slightly,
6
and push down on the locking lever tab
with your foot. The wheel should swing
down and lock. (Fig. 3)
Repeat at the other leg. Simply reverse
this action to retract the wheels. (Fig. 4)
USING THE WHEELS
With the wheels engaged, the Workcentre
can be moved by lifting the opposite end.
It's generally easier to pull rather than
push the Workcentre - especially on
lawns, sandy soil, uneven ground and
steps. Care should be taken when
wheeling down stairs.
NEVER OPERATE THE WORKCENTRE
WITH THE WHEELS ENGAGED. The
wheels must be retracted when operating,
and you should kick the Workcentre legs
outwards after moving it to make sure it is
stable.
Page 2
AWA 200