Connecting To A Stereo Amplifier; Connect The Lcd Monitor To A Stereo Amplifier; Basic Operation; Power On And Off Modes - NEC MultiSync LCD4010 Manuel Utilisateur

Connecting to a Stereo Amplifier

You can connect your stereo amplifier to your LCD monitor. Refer to your amplifier owner's manual for more information.

Connect the LCD Monitor to a Stereo Amplifier

• Turn on the LCD monitor and the amplifier only after all connections have been made.
• Use an RCA cable to connect the AUDIO OUT connector (RCA) on the LCD monitor and the audio input on the amplifier.
• Do not reverse the audio left and right jacks.
• The AUDIO IN is used for audio input.
• The AUDIO OUT jack outputs sound from the selected Audio input.

Basic Operation

Power ON and OFF Modes

The LCD monitor power indicator will turn green while powered on, or red when in off mode. The monitor can be powered on
or off using the following three options:
1. Pressing the power button.
Note:
Power Button
2. Using the remote control.
Note:
3. Pressing the Main Power Switch.
Note:
Main Power Switch
01_English
To audio right output
To audio
left output
RCA
To audio
RCA
right output
To audio left output
Before pressing the power button, be sure to turn on the Main Power Switch on the LCD
monitor.
Before operating the remote control, be sure to turn on the Main Power Switch on the LCD
monitor.
When the Main Power Switch is used to power off the LCD, the remote control and the power
button will not activate the on mode and both green and red power indicator turn off. Be sure
to turn the Main Power Switch to the on mode before using these two options.
16
LCD monitor
VCR or
Laser disc player
Amplifier
External speaker External speaker
English-16
08/09/2005, 16:26