Basic Operations; Power; To Turn The Unit On And Off; Volume - NEC PlasmaSync 50XM5 Guide Rapide

Basic Operations

POWER

To turn the unit ON and OFF:

1. Plug the power cord into an active AC power outlet.
2. Press the Power button (on the unit).
The monitor's POWER/STANDBY indicator turns red
and the standby mode is set.
3. Press the POWER ON button (on the remote control) to
turn on the unit.
The monitor's POWER/STANDBY indicator will light
up (green) when the unit is on.
4. Press the POWER STANDBY button (on the remote control)
or the Power button (on the unit) to turn off the unit.
The monitor's POWER/STANDBY indicator turns red
and the standby mode is set (only when turning off the
unit with the remote control).

VOLUME

To adjust the sound volume:

1. Press and hold the VOLUME
control or the unit) to increase to the desired level.
2. Press and hold the VOLUME
control or the unit) to decrease to the desired level.

MUTE

To mute the audio:

Press the MUTE button on the remote control to mute the
audio; press again to restore.

DISPLAY

To check the settings:

1. The screen changes each time the DISPLAY button is
pressed.
2. If the button is not pressed for approximately three seconds,
the menu turns off.

DIGITAL ZOOM

Digital zoom specifies the picture position and enlarges
the picture.
1. (Be sure ZOOM NAV is off.)
Press the POINTER button to display the pointer. (
To change the size of the picture:
Press the ZOOM+ button and enlarge the picture.
The pointer will change to resemble a magnifying glass.
( )
A press of the ZOOM- button will reduce the picture
and return it to its original size.
To change the picture position:
Select the position with the
2. Press the POINTER button to delete the pointer.

AUTO ADJUST

To adjust the size or quality of the picture
automatically:
Press the AUTO ADJUST button.
Information
AUTO ADJUST ON setting
When RGB (still picture) input is selected:
Fine Picture, Picture ADJ, Position, and Contrast will
be adjusted automatically.
When RGB (motion picture), VIDEO, or Y/Pb/Pr
(component) input is selected:
The screen size switches to ZOOM mode automatically
when a letter box image is displayed.

OFF TIMER

To set the off timer:

The off timer can be set to turn the power off after 30, 60,
90 or 120 minutes.
1. Press the OFF TIMER button to start the timer at 30
2. Press the OFF TIMER button to the desired time.
3. The timer starts when the menu turns off.
button (on the remote

To check the remaining time:

1. Once the off timer has been set, press the OFF TIMER
button (on the remote
2. The remaining time is displayed, then turns off after a few
3. When five minutes remain the remaining time appears

To cancel the off timer:

1. Press the OFF TIMER button twice in a row.
2. The off timer is canceled.
)
buttons.
En-10
minutes.
→ → → → →
30 60 90 120 0
OFF TIMER 30
button once.
seconds.
until it reaches zero.
OFF TIMER 28
OFF TIMER 0
Note:
After the power is turned off with the off timer ...
A slight current is still supplied to the monitor. When you
are leaving the room or do not plan to use the system for a
long period of time, turn off the power of the monitor.