Connecting The Power Cord - NEC LCD1515 Mode D'emploi

Quick Start

Connecting the Power Cord

· Check first to make sure that the power cord you use is the correct type required
for your area.
· This monitor has a universal power supply that allows operation in either AC 100-
240 V AC voltage area. No user-adjustment is required.
· Plug one end of the power cord to the AC Inlet, plug another end to a proper AC
outlet.
· If you use this monitor at AC125-240V, please refer to Recommended Use section of
this manual for proper selection of an AC power cord.
Installation
To install the monitor to your host system, please follow the steps as given below:
1. Connect Video Cable
a. Make sure both the monitor and computer are powered-OFF.
b. Connect the video cable to the computer.
2. Connect power cord
Connect the power cord to the monitor, then to a properly grounded AC outlet.
3. Power-ON Monitor and Computer
Power-ON the monitor first, then power-ON the computer.
4. If the monitor still does not function properly, please refer to the troubleshooting
section to diagnose the problem.
15151715manual042502.p65
–continued
5
5 4/25/03, 12:09 PM