Table des Matières
Publicité
14 electrolux
WHAT TO DO IF ...
Troubleshooting by yourself
If, during operation, the error code E... plus
number or letter) appears on the multi-dis-
play: Switch the appliance off and on again.
Problem
Dryer does not work.
Drying results unsatisfac-
tory.
When a button is pressed
- no reaction of the ma-
chine.
Drum light does not work.
Displayed programme
time changes erratically
or stays unchanged for a
long time.
Programme inactive,
CONTAINER display illu-
minated.
Drying cycle ends shortly
after programme starts.
ANTICREASE (ANTI-
CREASE) light is on.
Possible cause
Mains plug is not plugged in or
fuse is not working correctly.
Loading door is open.
Have you pressed the START/
PAUZE (START/PAUSE) button?
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with lint.
Overloading of laundry.
Ventilation slots in base area cov-
ered up.
Residue on inside surface of drum
or drum ribs.
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
Drying protection. After the start of
the programme, the option can no
longer be set.
Programme selector in O off posi-
tion.
Defective light bulb.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for selec-
ted programme.
Reset programme. Press the START/
PAUZE (START/PAUSE) button. If the error
appears again, please contact the Custom-
er Care Department, stating the error code
Plug in at mains socket. Check
fuse in fuse box (domestic installa-
tion).
Close loading door.
Press the START/PAUZE (START/
PAUSE) button again.
Select a different programme the
next time you dry (see "Pro-
gramme overview" chapter).
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading
volumes.
Uncover ventilation slots in base
area.
Clean inside surface of drum and
drum ribs.
Re-programme standard setting
for degree of drying (see 'Program-
ming options' chapter).
Turn the programme knob to O
off . Set the programme again.
Turn programme selector to any
programme.
Replace light bulb (see next sec-
tion).
Automatic process; this is not a
machine fault.
Empty condensate tank, then start
programme with START/PAUZE
(START/PAUSE) button.
Select time programme or higher
drying level (e.g.
(EXTRA) instead of
(CUPBOARD).
Remedy
Extra droog
Kast droog
Publicité
Table des Matières
