Installing The Battery Pack; Turning Off The Power; Trim Setup; Electronic Speed Control Setup - Maverick iON MT Manuel D'utilisation

Installing the battery pack

Turning off the power

Turn off receiver first and then turn off transmitter.
If you switch off the transmitter first before the R/C car, you may lose control of the R/C car.
•
•
Turn off the receiver switch.
•
Turn off the transmitter switch.
Disconnect the battery connector from the speed control connector.

Trim Setup

If the front tyres are not pointing straight forward with the transmitter on, adjust the steering trim. Then if needed make fine adjustments with the
steering trim whilst driving the vehicle.
If wheels point left, turn clockwise

Electronic Speed Control Setup

MSRS-28 - 2 in 1 Receiver/ESC 2.4GHz
1. With the speed control switch set to off, plug in a suitable battery pack.
2. With the transmitter switched on and throttle trim set to the centre, turn on the speed control.
3. To indicate the speed control is working correctly its LED will light constantly followed by 3 beeps
4. If necessary adjust the throttle trim of the transmitter so your car is stationary with no throttle or brake applied.
5. Your speed control is fully installed and ready to use.
Technical Information
•
•
20A drive FET's & 15A Reverse FET's
•
Case dimensions: 70mm*33mm*24mm
•
Silicone Wire 22 Gauge
•
Weight 25g with connectors and switch
BEC Voltage 6.0V
You need to insert the
battery pack in the open
section for the battery. Use
the strap provided to place
on top of the battery and
then use the retaining clip
to secure the battery.
If wheels point right, turn anti-clockwise.
Features
•
•
6.0Volt — 8.4Volt Power Input
•
Waterproof
•
High Frequency Drive System
Forward, Reverse & Brake Linear
•
Operation
•
Automatic Setup System
•
Over Current Protection
•
Thermal Protection
•
Low Voltage Protection
LED with audible beep
4
Once fastened and
secured please connect
the battery plug into the
speed controller plug
noting correct polarity. Red
to red, black to black.
DISCONNECT THE BATTERY
PACK AFTER USE!
If they point straight no adjustment required.