Compliance Information; Radio Interference - Philips AVENT SCD843 Instructions

32
English
VIDEO DISPLAY
Why isn't the image on
the video display clear?

Compliance information

The display brightness may be set too low. Increase the display brightness
on the parent unit using the control button in the centre (see 'Brightness').
Perhaps the lens of the baby unit is dirty. Clean the lens with a dry cloth.
The baby unit may be too far away from your baby. Make sure the baby unit
is not further than 1.5 meters / 5 feet away from your baby for optimal video
quality. Closer than 1 meter / 3.5 feet increases strangulation hazard.
This device complies with Part 15 of the FCC Rules and contains licence-
exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s). Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Radio interference

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of
Industry Canada. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.