LaserLiner LaserRange-Master i5 Mode D'emploi page 13

1.
2.
Switch on, measure and switch off:
Device on
1x
Change unit of measure:
m / inch / ft
3 sec
Change measurement point (reference):
Rear (device on)
To select functions:
Length / min/max continuous measurement / area / volume / angle
function 1 + 2 + 3 / digital bubble level / tilt sensor calibration / memory
Length
(device on)
1x
LaserRange-Master i5
3.
4.
Laser on
2x
1 sec
1x
1 sec
1 sec
1x
KEYPAD:
1. ON / measure
2. Delete last measurement
values / OFF
3. Measurement point (reference)
rear / front /
unit m / inch / ft
4. Length / min/max continuous
measurement / area / volume /
angle function 1 + 2 + 3 /
digital bubble level / tilt sensor
calibration / memory
Measure
3x
Delete the last
measured value:
Front
1x
Device off
3 sec
1x
13
EN