LEMAN SRU355 Manuel D'utilisation page 28

3.8 Setting the table square to sawblade
Tools Required :- Small 90 º square
(not supplied)
The table can be set at 90º to the sawblade
Fig. 9 by adjusting the table stop screw
underneath the table.
The table stop screw rests on the top of the lower
wheel bandwheel housing. By, first slackening the
locking nut (A) and then adjusting the screw (B)
the table can be set correctly. Re-tighten the
locking nut (A) making sure that the setting is
maintained. Fig. 10
3.9 Adjusting the rip fence guide scale
Tools Required:- 10mm Wrench
Straight edge
To adjust the rip fence scale loosen the four
winged screws (see K Fig. 4) below the table
and move the scale and rip fence guide (C)
Fig. 11 sideways to adjust. Re-tighten the winged
screws when the adjustment is correct.
The adjustment can be checked by setting the
rip fence to a thickness and cutting a test piece.
When the adjustment is correct the thickness of
the test piece will correspond with the rip fence
scale setting.
3.10 Checking the table for flatness
Once the scale is set to the desired position the
table should be checked for flatness. This can be
done by using a steel rule as a straight edge.
The steel rule should be held on the table across
the table slot close to the front edge of the table.
(See Fig. 12)
If the straight edge shows there is a step across
the table slot then the table needs to be adjusted
using the two screws and locking nuts provided for
this purpose, located on the underside of the rip
fence guide, at (D) Fig. 12
- 4 -
GB
Fig. 9
Fig. 10
A
B
C
Fig. 11
D
Fig. 12