Fence Adjustment - LEMAN SRU355 Manuel D'utilisation

3.4 Fitting the Crank Handle
Tools Required :- Flat bladed screwdriver
10mm wrench
Attach the crank handle (A) to the belt tension
crank arm with the M6 x 55 slotted cheese head
screw and two M6 nuts. Fig. 5
3.5 Assembling the Rip Fence
The rip fence on this bandsaw can be used on
either side of the blade by fixing the rip fence
extrusion (C) to the appropriate side of the rip
fence casting (B). Fig. 6
To assemble the rip fence take the rip fence
casting (B) Fig. 6 and attach it to the bandsaw
table using the M8 x 50 coach bolt and plastic
winged nut. (F) Fig. 6
Fit the rip fence extrusion (C) to the rip fence
casting (B) with the two small knurled knobs and
M6 x 40 coach bolts (D) and use the large knob
(E) for adjustment and to lock in position as shown
in
Fig. 7

3.6 Fence Adjustment

Vertical and horizontal alignment of the rip fence is
made by adjusting the two small knurled knobs (D)
and the large centre knob (E). Fig. 7
The fence should be aligned with the table slots
along its length and adjusted vertically with a
suitable square placed on the table surface.
3.7 Centering the table to the blade
Tools Required:- 13mm wrench
To centre the table to the blade loosen the 4 M8
nuts (G) Fig. 8 which hold the lower trunion to the
machine frame.
Slide the table sideways until the blade is at the
centre of the slot in the table insert.
Re-tighten the 4 nuts making sure the table
remains in its set position.
B
G
Fig. 8
- 3 -
GB
Fig. 5
A
Fig. 6
E
F D
C
Fig. 7
E
D
F