Guide Bar Maintenance; Check The Chain Lubricant; Adding Chain&Bar Lubricant; General Maintenance - McCulloch Li 40CS Manuel D'utilisation

GUIDE BAR MAINTENANCE

• When you have finished working, clean out the
groove and the oil passages with a scraping hook.
• Periodically trim the sides of rails using a flat file. If
not done in the long run, the feather edges might
break away and damage the bar.
• If one rail is higher than the other one, it is necessary
to make it even with a flat file then smooth it with a
file or fine grain abrasive paper.
WARNING! When servicing, use only
!
identical replacement parts. Use of
any other parts may create a hazard
or cause product damage.
WARNING! To avoid serious personal
!
injury, always remove the battery pack
from the tool when cleaning or perform-
ing any maintenance.
CHECKING THE CHAIN LUBRICANT
• Check the amount of oil in the chainsaw by looking
at the oil level gauge.
WARNING! Check the saw chain ten-
!
sion before each use of the chainsaw.
WARNING! Never operate the chainsaw
!
without sufficient saw chain lubrica-
tion as this might damage the chain-
saw and is a threat to safety. Check
the saw chain lubricant level before
each use!
ADDING SAW CHAIN & BAR LUBRI-
CANT
• Unscrew and remove the cap from the oil tank.
• Pour the oil into the oil tank and monitor the oil level
gauge. Ensure that no dirt enters the oil tank while
pouring the oil in.
• Put the oil cap back on and tighten it up.
• One full oil tank will enable you to use the chainsaw
for 20- 40 min.
14 - English(Original Language)
MAINTENANCE

GENERAL MAINTENANCE

Before each use, inspect the entire product for dam-
aged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and
caps and do not operate this product until all missing
or damaged parts are replaced. Please call Customer
Service for assistance.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
!

STORAGE

STORING THE PRODUCT

• Remove the battery pack from the unit before
storing.
• Clean all foreign material from the unit.
• Store it in a place that is inaccessible to children.
• Keep away from corrosive agents such as garden
chemicals and de-icing salts.
• Store and charge your batteries in a cool area.
Temperatures above or below normal room
temperature will shorten battery pack life.
• Never store batteries in a discharged condition. Store
battery packs in a 30%-50% charged condition.
• Store the battery pack where the temperature is
below 27°C and away from moisture.
• All batteries gradually lose their charge. The higher
the temperature, the quicker they lose their charge.
If you store your unit for long periods of time without
using it, charge the pack as normal every six months
of storage. This practice will prolong battery pack life.
WARNING! Do not at any time let brake
liquids, gasoline, petroleumbased
products, penetrating oils, etc.,come in
contact with plastic parts. Chemicals can
damage, weaken or destroy plastic
which may result in serious personal
injury.