Table des Matières
Publicité
CAUTION WHEN USING THE RC MODEL
TROUBLE SHOOTING
Problem
Model does not move
No control
Motor stops suddenly during
normal operation
GB // 26
Cause
Model has no contact with water
Weak or no battery in the model
The overheat cut-out has stopped the model due
to overheating
Weak rechargeable battery/battery in transmitter
or model
Receive is being affected by interfering signals
The function of the drive controller has been
stopped by the integrated safety shutoff for low
battery pack voltage or overheating
Never use the model in inhabited waters or in the vicinity of people
or animals in order to prevent damage to objects or persons.
• Never use the model on waters containing algae or dirt. The
propeller could be impeded by grass winding around it and
cause the motor to overheat.
• Do not use the model in flowing water.
• Never use the model on public waterways, since this could put
shipping traffic at risk.
Solution
Put model into water
Insert fully charged battery
Switch off the receiver. Allow the RC model to
cool down for approximately 30 minutes
Insert fully charged battery or new battery
Move out of the affected area and start operation
elsewhere.
Replace the drive battery pack with a fully
charged battery pack or wait until the electronics
have cooled down.
Publicité
Chapitres
Table des Matières
