Table des Matières
Publicité
Brushless Version 500108027
1. Switch the transmitter on first.
2. Now connect the drive battery pack to the drive controller in the boat. (Fig.1)
(acoustic signal is emitted)
3. Check the steering function on the boat stand. (Fig.3)
4. Put the boat into the water and check the drive function.
5. Do this by operating the boat at slow speed, and do not go far from the waterside.
6. If the boat will not move in a straight line, adjust the steering trim "ST Trim" on the
remote control.
7. If all functions are working properly, you can set off.
Binding:
Attention!!! The boat is fully functional when it leaves the factory.
Only use the binding procedure if a malfunction occurs or the drive controller unit
has been replaced.
Binding procedure / fail-safe setting See separate instructions "Reflex Wheel Pro
3" !!
Typical drive controller data:
Model:
Brushless drive controller, sensorless
Input voltage:
6-13 V
LiPo battery pack:
2-3 cells
BEC output:
5V-3A
Output /
continuous current:
40A
Motor: Brushless
Motor
Controller settings
Drive mode: forwards/reverse
Battery pack: automatic cell detection
Lithium battery pack shut-off 3.2V /cell
1
3
23 // GB
2
Publicité
Chapitres
Table des Matières
