Ordering Information - DENTSPLY digit power Manuel D'utilisation

Distributeur

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

INSERT CONVERSION

For conversion of digit power

™

Regulators from and to any of the following configurations: ISO Threaded Connector; MIDWEST

StarDental HiFlo

Insert; KaVo MULTIflex

• Step 1: If converting a coupler system to another coupler system skip to Step 3. NOTE: Coupler insert may vary from photos depending on configuration.

• Step 2: If converting an ISO threaded connector to a coupler system, remove the ISO connector from the bottom of the regulator using a wrench (not provided).

Turn counter clockwise to remove. Skip to Step 5.

• Step 3: If converting a coupler system to another coupler system, remove the old insert from the bottom of the regulator using the 5/32 hex key.

Turn counter clockwise to remove.

• Step 4: Important: Ensure that the o-ring on the coupler insert is also removed and not lodged inside the regulator body.

• Step 5: Thread the desired coupler insert into the bottom of the regulator using caution to avoid cross threading the parts. Turn clockwise to install.

• Step 6: Tighten the coupler insert using the 5/32 hex key. Turn clockwise to tighten.

Step 2

Step 5