Preparation; Subwoofer Connection - Grundig GSB 910 SW Mode D'emploi

PREPARATION/CONNECTION

Preparation

Activate the remote control battery
1
Remove protection film from the battery com-
partment.
– The remote control is now functional.
Change remote control batteries
(TYPE AAA)
Note:
If your device no longer responds to the
7
remote control commands, the battery may
be dead. It is imperative that dead batteries
be removed. We do not assume liability for
damage caused by leaked batteries.
Caution:
Danger of explosion if battery is incorrectly
7
replaced. Replace only with the same or
equivalent type.
1
Hold the remote control with the back side fac-
ing up.
2 Push the detent of the battery holder to the right
and remove battery holder.
3
Remove used battery and insert new battery
into the battery holder, positive pole facing up-
ward.
4
Push battery holder into the remote control until
it clicks into place.
Connecting
Connect Soundbar to the LCD TV
1 Connect a standard audio lead to the
»AUX INPUT« jacks of the Soundbar.
– Please be aware of the left and right chan-
nels when doing so (white = left channel,
red = right channel).
2
Connect audio lead to the audio output jacks
of the LCD TV.
Connect external device
An external device, such as a MP3-Player for ex-
ample, can be connected to the
1
Connect a standard audio lead to the
»AUX IN« jack of the Soundbar.
2
Connect mains cable
Check that the mains voltage indicated on the
type label (on the back of the device) corre-
sponds to the local mains voltage. If this is not the
case, please consult your specialist dealer.
1

Subwoofer Connection

1
2
3
»AUX IN« jack.
----------------------------------------------------------
Connect adapter cable to the external device.
Note:
The LCD TV can also be connected via the
7
»AUX IN« jack if it is not equipped with au-
dio output jacks. In such cases please use the
headphone jack.
Plug mains cable plug into the socket
(100 - 240V ~ 50/60Hz).
Caution:
The Soundbar is connected to the mains via
7
the mains cable. If you want to disconnect
the Soundbar from the mains completely,
you must pull the mains plug.
Please ensure that the mains cable is freely
7
accessible during operation and is not ob-
structed by any other objects.
Make sure the AC power cord is connected to
a power supply securely.
Subwoofer have the wireless bluetooth to
receive the audio signal from the sound bar.
When the blue indicator flashing, the subwoof-
er is in searching bluetooth signal status, the
blue indicator keeps lighting means bluetooth
was connected, if the subwoofer can not con-
nect with the soundbase automatically, please
press pair button on the rear panel of subwoof-
er to reconnect.
The subwoofer will memories the sound bar
and repaired automatically when you power
off the subwoofer then power on.
GSS1010
DSB 990 2.1
Made in P.R.China
ENGLISH
17