Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
M
d
agnEtiC
Rill
• Always inspect the whole unit before use.
• Regular maintenance is essential - check
nuts, screws etc. for tightness before each
use.
• Check cable and plug for damage.
• Never use blunt or damaged cutters.
• Never use a larger diameter cutter than
specified for the machine
• Always use the safety guards (where
fitted).
• Always wear goggles and gloves
• Secure the unit with the safety strap
before drilling.
• Always disconnect from the power source
before changing cutters or working on the
machine.
• Remove rings, watches, ties etc. that
could tangle in the moving parts.
• Keep the unit and workpiece as clear of
dirt and shavings as possible.
• On swivel machines, ensure that the
swivel base is locked in the required
position.
• Do not attempt to change speed while
the drill is running.
• Only use accessories recommended by
the manufacturer.
• Never modify the tool in any way.
S
i
aFEtY
nStRuCtiOnS
M
aintEnanCE
• Occasionally apply a few drops of oil
to the rack toothing.
• The bearings of the feed shaft are self-
lubricating and must not be greased
• Lubricate the sliding surface of the
carriage with MOLYCOTE grease.
• When not in use or being transported the
unit should be kept in the case supplied.
• After use ensure unit is clean of swarf
and dirt.
• Parts that are worn or damaged should
be replaced immediately with genuine
manufacturer's replacements.
• Ensure all cutting edges are sharp when
in operation. Using blunt cutting tools may
lead to an overload of the motor.
• After every 30 minutes running, it is
recommended that the machine is laid on
its side to permit grease to run across the
gear train.
IMPorTANT MeSSAGe!
TO PREVENT DAMAGE TO THE CIRCUITRY, NEVER USE ELECTROMAGNETIC DRILLING
MACHINES AND WELDING EQUIPMENT ON THE SAME WORKPIECE SIMULTANEOUSLY.
i
nStRuCtiOnS
• After repeated use, the cradle may
become loose. This is remedied by
adjusting the tension screws on the side
of the body. Put a 2.5mm hex wrench
into head of cradle retaining nuts, &
using 8mm spanner turn the locking nuts
anti-clockwise, holding the hex wrench
without moving grub screws.
Using the hex wrench gently tighten
screws in series until the cradle moves
freely in the slide but does not allow the
motor to wobble.
When adjustment is complete re-tighten
locking nuts clockwise, ensuring the
grub screws do not move from their new
positions.
7
Publicité
Table des Matières
