Unibor EQ50 Guide page 6

g S
EnERal aFEtY
1. KNOW YOUR POWER TOOL
Read and understand the owner's manual and
labels fixed to the tool. Learn its application
and limitations as well as the potential hazards.
2. EARTH ALL TOOLS
Ensure that (where applicable) suitable earthed
cords and plugs are used and correctly
connected.
3. KEEP GUARDS IN PLACE (where applicable)
-in working order, and correct adjustment and
alignment.
4. REMOVE ADJUSTING KEYS AND
WRENCHES.
form a habit of checking to see that keys and
adjusting wrenches are removed from tool
before turning it on.
5. KEEP WORK AREA CLEAN
Cluttered areas and benches invite accidents.
floor must not be slippery due to oils, or dust.
6. AVOID DANGEROUS ENVIRONMENTS
Don't use power tools in damp or wet locations
or expose them to rain. Keep work area well
lighted. Provide adequate surrounding work
space.
7. MAKE WORKSHOP SAfE
Use padlocks, master switches, remove keys.
Visitors should be a safe distance from work
area.
6
i
nStRuCtiOnS
8. DON'T fORCE TOOL
It will do the job better and more safely at the
rate for which it was designed.
9. USE CORRECT TOOL
Don't force tool or attachment to do a job it was
not designed for.
10. WEAR PROPER APPAREL
Do not wear loose clothing, gloves, neckties or
jewellery (rings, wristwatches) which may get
caught in moving parts.
NONSLIP footwear is recommended.
Wear protective hair covering to contain long
hair. Roll long sleeves above the elbow.
11. USE SAfETY GOGGLES. (Head Protection)
Wear approved safety goggles at all times.
Everyday eyeglasses only have impact resistant
lens, they are NOT safety glasses. Also, use
face or dust mask if cutting operation is dusty,
and ear protectors during extended periods of
operation.
12. SECURE WORK.
Use clamps or a vice to hold work when
practical. It's safer and frees both hands to
operate tool.
13. DON'T OVERREACH.
Keep proper footing and balance at all times.
14. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for best and safest
performance. follow instructions for lubricating
and changing accessories.
15. DISCONNECT TOOLS before servicing;
when changing accessories such as cutters, etc.
16. USE RECOMMENDED ACCESSORIES.
Consult owners manual for recommended
accessories. follow the instructions that
accompany the accessories. The use of
improper accessories may cause hazards.
17. CHECK fOR DAMAGED PARTS
Before further use of the tool, a guard or other
part that is damaged should be carefully
checked to ensure that it will operate properly
and perform its intended function. Check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any
other conditions that may affect operation. A
guard or other part that is damaged should be
properly repaired or replaced.
18. NEVER LEAVE TOOL RUNNING
UNATTENDED.
Turn power off. Don't leave tool until it comes
to a complete stop.