Unibor EQ50 Guide page 8

F
itting thE
d g i
Rill uaRd nStRuCtiOnS
Ensure drill unit is isolated from power supply.
TyPe 1 - This type uses a single screw to fix
the guard to the drill.
fit guard to drill in position shown in fig. 1.
Secure the guard to drill with the screw
supplied. DO NOT overtighten the fixing
screw, this should be loose enough to allow the
guard to rise when required. Lower the guard
to drilling surface. When drilling, the guard
should always be in contact with the surface
being drilled. As the drill is lowered, the guard
will rise in relation to the drill.
TyPe 2 - This type uses two screws to support
the guard in position, one either side of the
drill.
If necessary press the plastic guard guides
into their locating holes on ether side of the
motor cradle
fit guard to drill as shown in fig 2.
Secure guard to drill with screws and washers
supplied. DO NOT overtighten the fixing
screws, these should be loose enough to allow
the guard to rise when required. Lower guard
to drilling surface.
When drilling, the guard should always be in
contact with the surface being drilled. As the
drill is lowered, the guard will rise in relation
to the drill.
8
S g
aFEtY uaRd
Fig. 1
F
itting thE
(S
tandaRd
Fig. 2
C
uttER
a )
RBOR
Fig. 3
Fig. 4