Water Dispenser Tank (Non Plumbed Models Only) - LG GSX960NEAZ Manuel Du Propriétaire

Setting and Resetting Lock
This locks the buttons on the control panel.
• When you press the Lock button for three
seconds, the Set/Reset icon on the control
panel lights. The function is enabled and
disabled in turn each time you press the
button.
• If you press a button other than lock when the
lock is set, the button will not function.
• When you press a button other than lock when
the lock is set, the Set/Reset icon on the
control panel will flash 3 times.
• To change a setting, first press the Lock button
for three seconds to disable the function.
Setting Wi-Fi
The Wi-Fi button, when used with the LG Smart
ThinQ application, allows the refrigerator to
connect to a home Wi-Fi network.
• The Wi-Fi icon shows the status of the
refrigerator's network connection. The icon
illuminates when the refrigerator is connected
to the Wi-Fi network.
• Press and hold the Wi-Fi button for 3 seconds
to connect to the network. The icon blinks while
the connection is being made, then turns on
once the connection is successfully made. To
disconnect, press and hold the button again.
Water Dispenser Tank (Non
plumbed models only)
The water tank holds the water in which is to be
dispensed or used by the automatic ice maker
to make ice. Do not fill this tank with any other
liquid other than water. Doing so can damage
the water dispensing system.
1
Remove the water dispenser tank by pulling
it out while holding the handle.
2
Open the cover or cap of the water
dispenser tank.
3
Fill with bottle filtered or clean filtered water
up to the reference line indicated inside the
water dispenser tank. (Total capacity: 4 ℓ)
ET
27