Intended Use - Black & Decker BD200MT Mode D'emploi

A.) On/Off switch
B.) Variable speed dial
C.) Power cord
D.) Tool-Free Release
Sanding in extremely tight areas otherwise difficult to reach and require hand sanding.
Detail Sanding
Select a high oscillating frequency. Sand with continuous motion and light pressure.
Applying excessive pressure does not increase material removal but will prematurely
wear sanding sheets.
Remove excess wood from door jamb, window sill and/or toe kick. Removing excess
Flush Cutting
copper or PVC pipe.
Carpets & backing, old tile adhesives, caulking on masonry, wood and other surfaces.
Removal Work
Tile grout, plaster, mortar splatters, concrete on tiles, sills.
Removal of Excess Materials
New floors and tiles.
Preparation of Surfaces
Disconnect the plug from the power source before making any
assembly, adjustments or changing accessories. Such preventive safety measures
WARNING:
reduce the risk of starting the tool accidentally.
immediately after operating the tool. They can become very hot. Handle carefully.
WARNING:
Always allow workpiece and accessories to cool before handling.
Installing/Removing
The BD200MT features an exclusive tool-
Accessories
free accessory changing system. This
allows for faster accessory changes
without the need for wrenches or hex
keys like other oscillating tool systems.
• Grasp the tool and squeeze the
accessory clamping lever as shown in
figure 1.
• Clean any residual debris from the tool
shaft and the accessory holder.
COMPONENTS

INTENDED USE

Risk of lacerations or burns. Do not touch workpiece or blade
A
D
ASSEMBLY
1
6
B
C