Black & Decker BD200MT Mode D'emploi page 8

Be sure switch is fully OFF before plugging in the power cord.
Switch
CAUTION:
Because the BD200MT has a separate speed dial for setting the speed
CAUTION:
(1-6), the tool will start at the speed where the speed dial is set.
• Plug in power cord.
• To turn the tool ON, hold it as shown in
figure 5 and push the slide switch
forward.
• To turn the tool OFF, push the slide
switch backward.
To operate the tool, select the speed setting you wish with the speed dial, shown in
Variable Speed Dial
figure 6, and slide the ON/OFF switch forward. The speed setting can be adjusted
either with the tool on or off.
Be sure switch is fully
OFF before plugging in the power cord. CAUTION:
Because the BD200MT
has a separate speed dial for setting the CAUTION:
speed (1-6), the tool will start at the
speed where the speed dial is set.
The numbered positions,1 through 6
inscribed on the variable speed dial, do
not indicate any precise speed but are
good reference points. The higher the
number, the higher the tool speed.
The approximate speed at each setting is:
SPEED SETTING
OSCILLATIONS PER MINUTE
(Actual oscillations per minute on your tool may vary.)
Be sure to select the proper speed for your oscillating tool operation. In general, use
lower speeds (1-3) for cutting metal and PVC or plastic materials and use higher
speeds (4-6) for sanding, removal & wood cutting applications. For paint, varnish, or
other finish removal, use the lowest speed setting (1) to get the maximum life from the
sanding sheet.
If in doubt about the proper speed for your operation, test the performance at low
speed settings and gradually increase until a comfortable speed is found.
OPERATION
5
6
1 2
10,000 12,000
8
3 4
14,000 16,000
5 6
18,000 20,000