Braun 730s-4 Mode D'emploi page 7

Cleaning
Regular cleaning ensures better shaving
performance. Rinsing the shaver head under
running water after each shave is an easy and
fast way to keep it clean:
• Switch on the shaver (cordless) and rinse the
shaver head under hot running water until all
residues have been removed. You may use
liquid soap without abrasive substances.
Rinse off all foam and let the shaver run for a
few more seconds.
• Next, switch off the shaver, press the release
2
button to remove the Foil & Cutter cassette
1
and let it dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil on top of the Foil & Cutter
cassette.
Alternatively, you may clean the shaver using a
brush:
• Switch off the shaver. Remove the Foil & Cutter
1
cassette and tap it out on a fl at surface.
Using the brush, clean the inner area of the
pivoting head. However, do not clean the foil
and cutter cassette with the brush as this may
damage it.
Keeping your shaver in top shape
Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance,
replace the Foil & Cutter cassette
replacement symbol lights up on the shaver
9
display (after about 18 months) or when
cassette is worn.
The replacement symbol will remind you during
the next 7 shaves to replace the Foil & Cutter
cassette. Then the shaver will automatically reset
the display.
After you have replaced the Foil & Cutter
cassette, use a ball-pen to push the reset button
8
for at least 3 seconds to reset the counter.
While doing so, the replacement light blinks and
goes off when the reset is complete. The manual
reset can be done at any time.
1
, when the
Series
Ser ies
r e l e as e
Series 7
r e l e as e
Series 7
r e l e as e
Series 7 Series 7
r e l e as e r e l e as e
Series 7 Series 7
r e l e as e r e l e as e
r e l e as e r e l e as e
70S
Series 7
r e l e as e
7