Braun 195s-1 Mode D'emploi page 5

Charging
Recommended ambient temperature for charging is 5 °C to 35 °C.
The battery may not charge properly or at all under extreme low or high
temperatures. Recommended ambient temperature for shaving is 15 °C
to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for
extended periods of time.
• When charging for the first time or when the appliance is not used for a few
months, leave the appliance to charge continuously for 4 hours.
• The charging light shows that the appliance is being charged. When the battery
is fully charged, the charging light turns off. Intermittent blinking after a while
indicates that the battery maintains its full capacity. This can also happen short
term when charging after the battery was completely discharged.
• Once the shaver is completely charged, discharge the shaver through normal
use. Then recharge to full capacity. Subsequent charges will take about 1 hour.
• A full charge provides up to 40 minutes of cordless shaving time depending
on your beard growth. However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• The red low-charge light (7) (only model 199s) flashes when the battery is
running low. You should be able to finish your shave.
• If the rechargeable batteries are discharged, you may also shave by con-
necting the shaver to an electrical outlet via the special cord set.
• 5-minute quick charge is sufficient for a shave.
Shaving
First, remove protection cap (1a). Press the on/off switch (4) to turn the shaver on.
Trimmer
To trim sideburns, moustache or beard, slide the long hair trimmer (5) upwards.
Remove foil protection cap (1a) upfront.
Tips for the perfect shave
For best shaving results, Braun recommends you to follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
Cleaning
Regular cleaning ensures better shaving performance. Rinsing the shaver head
after each shave under running water is an easy and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse the shaver head under hot running
water. A natural based soap may also be used provided it contains no particles
96621369_199s_S4-70_CEE.indd 5 96621369_199s_S4-70_CEE.indd 5
OVED Effective Date 3Feb2014 GMT - Printed 29Sep2015 P
5
30.01.14 15:05 30.01.14 15:05