Assembly Instructions - Nexgrill 720-0697E Mode D'emploi

Phillips Screwdriver (not included) and Wrench (not included)

Note: The right and left sides of the grill are designated as if you are facing the front of the grill.

ASSEMBLY INSTRUCTIONS

1. Cart Caster and Cart Assembly
a) Place the Cart Caster Insert (K) into the Cart Leg,
Front Left (F) and Cart Leg, Back Left (G).
As shown in Fig. 1.
b) Loosen, but do not remove the screws that are
pre-assembled on the Cart Leg, Front Left (F) and
Cart Leg, Back Left (G). Attach Cart Leg, Front
Left (F) and Cart Leg, Back Left (G) to Cart
Frame (H), by aligning the holes on the Cart Frame (H).
Tighten the screws that were loosened above.
Attach 2pcs left side panels (ZC) to cart leg, by aligning the
holes on the cart leg. Tighten the screws that were
loosened above.
Note: Make sure the flat side of Cart Frame (H)
faces inside to the right when attaching. As shown
in Fig. 2.
c) Loosen, but do not remove the screws that are
pre-assembled on the Cart Leg, Front Right (I)
and Cart Leg, Back Right (J). Attach Cart Leg,
Front Right (I) and Cart Leg, Back Right (J) to
Cart Frame (H), by aligning the holes on the Cart
Frame. Tighten the screws that were loosened above.
Attach 2pcs right side panel (ZC&ZD) to cart leg(the side
panel with hole assemble on the top), by aligning the holes
on the cart leg. Tighten the screws that were loosened above.
Note: Make sure the flat side of Cart Frame (H) faces
inside to the left when attaching. Side panel with hole
should be upward and side panel without hole should be
downward. As shown in Fig. 3.
Fig. 1
K
Fig. 2
ZC
Fig. 3
H
9
F
H
G
F
ZD
J
G