Installation Instructions - Nexgrill 720-0697E Mode D'emploi

18. Liquid Propane Tank Installation
From the rear side of the grill,
place the liquid propane tank into the
Bottom Panel(beer) hole.
Secure and tighten the Tank Bolt(Q)
to the bottom panel.
Always keep the LP cylinder at
90° (upright) orientation to
provide vapor withdraw.
19. Liquid Propane Hook-Up
a) Attach the regulator to the propane cylinder by
routing the regulator hose through the side of
the cart. As shown in Fig. 24.
Note: Make sure the hose and regulator placing in
the hole of top side panel to connect the tank.
b) Attach the regulator to the propane cylinder by
turning the regulator handle clockwise as shown
in Fig. 25. If the outdoor cooking appliance is not
in use, the gas must be turned "Closed" position
at the Liquid Propane Cylinder.
Check all gas supply fittings for leaks before
each use. Do not use the grill until all connections
have been checked and do not leak (see "Leak Testing"
instructions on page 18).

INSTALLATION INSTRUCTIONS

GAS HOOK-UP
Only the pressure regulator and hose assembly supplied with the grill should be used. Any replacement
pressure regulator and hose assembly must be specified by the grill manufacturer.
This grill is configured for Liquid Propane. Do not use a Natural Gas supply.
Total gas consumption (per hour) with all burners set on "HI":
Main burners
Side burner
Total
48,000 BTU/Hr.
12,000 BTU/Hr.
60,000 BTU/Hr.
Fig. 23
Fig. 24
Fig. 25
17
Propane Cylinder
Regulator