Nexgrill 720-0697E Mode D'emploi page 10

2. Bottom Panel Assembly
a) Loosen, but do not remove the screws that are
pre-assembled on the side of the Bottom Panel
(B), align the holes on the Cart Leg, Front Left (F)
and Cart Leg, Back Left (G), then place the Cart
Legs onto the screws that were loosened in the Bottom
Panel (B). As shown in Fig. 4.
b) Tighten the screws from outside to inside. There is
a hole in the outside of the cart leg. As shown in Fig. 4.
c) Repeat step 2a and 2b to attach right legs to the bottom
panel making sure all screws are tight.
3. Triangle Bracket Assembly
a) Loosen, but do not remove four screws on Bottom
Panel (B), two screws on Cart Leg, Back Left (G)
and two screws on Cart Leg, Back Right (J). Align
the holes of the Triangle brackets with the screws
in the Bottom Panel (B) and Cart Leg, Back Left (G)
and Cart Leg, Back Right (J) to connect Triangle
Bracket, Left and Right (P,O) to Cart Leg, Back
Left (G) and Cart Leg, Back Right (J). As shown in Fig. 5.
b) Tighten the screws that were loosened in step 3a.
Note: The flat portion of the triangle should face
the rear of the grill.
4. Front Panel Assembly
a) Loosen, but do not remove the screws which
are pre-assembled on the cart legs, align the
holes on the front panel (S) with the screw in
the legs, then place the front panel (S) onto
the screws in the cart legs. As shown in Fig. 6.
b) Tighten the screws that were loosened in step 4a.
Note: Flat facing side of the front panel (S)
should face out.
Fig. 4
F
Fig. 5
G
B
Fig. 6
S
10
G
B
p
J
O