Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Guide lubrication.
•
Move the carriage to the side and clean off any grease with a dry cloth.
•
Apply grease to the guide surface making sure it is well covered and lubricated.
•
Lubrication can be done on a weekly basis.
Pusher Axle lubrication.
•
Begin by cleaning with a dry cloth.
•
Apply cooking oil on both sides of the axle and move the pusher up and down to ensure the oil spreads
well.
•
Axle can be lubricated daily.
Sharpener lubrication.
•
Ensure sharpener axle is clean before beginning.
•
Apply cooking oil to both sides of axle.
•
Turn around and slide the axle until the axles work well.
Localizing head lubrication.
•
Adjust the fixing positioner counter clockwise to maximum length.
•
Clean the localizing head before applying cooking oil onto it.
•
Turn fixing positioner back to the original position.
•
This can be done weekly.
•
Be sure not to spread too much oil.
BLADE SHARPENING
1. Blade should be sharpened when slice thickness looks uneven or when the slices look broken.
2. Clean the edge of the blade before sharpening.
3. Pull out the sharpener and lubricate it to ensure it works properly.
4. Pull the sharpener out and turn 180º, press the right side stone down by finger then put the sharpener to
the working position.
5. Ensure that the stone's surface and the blade's edge are close to each other. If they are not, the please
perform necessary adjustments.
6. Run the machine for approximately 2 minutes before turning it off to inspect the blade. If the blade is not
sharp enough, repeat the procedure.
7. Press down the left side of the stone and make sure the surface of the stone is nesting closely to the
surface of the blade. Then sharpen for about 3 seconds to remove the burr.
8. Return the sharpener back to its original position once work is complete.
9. In order to get best results, keep the stone clean.
10. Refrain from looking directly or having one's face too close to the rotating stone. This could result in injury
from a piece of stone.
CLEANING
1. Always turn off and unplug the machine before cleaning. The slice thickness regulator should be set to the
zero position.
Maintenance
7
Publicité
Table des Matières
