Eaton Cooper Lighting PORTFOLIO C6042 Instructions D'installation

ADP140646
Installation Instructions – C6042, C7042 and C8042 Commercial
Recessed Compact Fluorescent Rough-In
Instructions d'installation – pose préliminaire du luminaire
fluorescent compact encastré commercial C6042, C7042 et C8042
Instrucciones de instalación de luminarias fluorescentes compactas
empotradas de uso comercial para áreas ocultas C6042, C7042 y
C8042
IMPORTANT: Read carefully before installing fixture.
Retain for future reference.
WARNING
Risk of Electrical Shock! Disconnect power at fuse or
circuit breaker before installing or servicing.
WARNING
Risk of Fire! Do not install insulation within 3 inches
(76 mm) of any part of the luminaire (fixture) or in a
way that may entrap heat.
N otee: This fixture should be supported by main runners
or other structure that is capable of supporting
fixture weight of 10 Ibs.
INSTALLATION
To Install Rough-In Section
1. Install fixture into ceiling cavity using 1/2" electrical
conduit. Use 3/4" channel, 1-1/2" channel,
1/8 x 1/2" bar stock, or T-bar fasteners as mounting
rails (furnished by others) by inserting the through
hanger brackets at both ends.
2. Adjust hanger adjustment screws so bottom of
plaster ring is flush with finished ceiling line. Hanger
bracket is reversible for a total adjustment of 5" .
(Figure 1.)
3. Remove one of the junction box covers. Connect
supply lead wires to lead wires of ballast per wiring
diagram and in accordance with your local electrical
code(s) or N.E.C.
IMPORTANT SAFEGUARDS: When using electrical
equipment, basic safety precautions should always be
followed, including the following:
READ AND FOLLOW THE SAFETY INSTRUCTIONS
1. This unit is for recessed mounting only. Do not use in
hazardous locations nor near gas or electric heaters.
2. Do not use this equipment for other than the intended
use.
3. Install only in accordance with National Electrical Code
and local regulatory agencies' requirements.
WARNING
Installation and servicing to be performed only
by qualified personnel. If not qualified, consult an
electrician.
6042
8042
3
2
Spring
Settings
1
Figure 1.
TM
INS #
Hanger Bar
Adjustment
Screw