Leviton evr-green EVR30-B1C Guide D'installation page 8

Install Your Hardwired Charger
(continued)
208V 3-Phase, Wye-Connected -
WARNING: The 208V feed is from a y-connection power grid, and the AC charger
can connect to L1 and L2, L2 and L3, L1 and L3. Earth ground must be connected to
neutral at only one point, usually at the breaker panel. Leave the unused leg open. Do
not connect it to a Neutral bar, or to ground. Be sure the center point is Earth ground
somewhere in the system.
1.
Choose location.
a.
Mark center of stud.
NOTICE: The unit should be
mounted high enough from grade
that the height of the storage
means for the charging plug is
located between 24 in and 4 ft
from the floor (NEC
This does not apply in Canada.
b.
Mark drilling holes.
L3 (NOT USED)
120V
(NOT USED)
120V
Article 625).
®
8
L1
120V
NEUTRAL
L2
GND
Stud
Template
U P
U P