How It Works; After Use; Cleaning And Care - GlobalMIND VenenWalker basic Mode D'emploi

How it works:

Your legs are massaged by the rhythmic and alternating in ating and de ating air
cushions. This massaging of your legs has the same effect on your veins and muscles
as a slightly strenuous walk. For the best results, your legs should be positioned hori-
zontally or raised during use so that the blood can circulate unimpeded.
We recommend using the device for approximately 20 - 30 minutes.
Please note that your legs are massaged one after the other by the in ating
and de ating air cushions, not simultaneously. The pressure is built up  rstly
in one leg cuff and then in the other. This is not a sign that the device is faulty!

After Use

Once you have  nished use, the air must be removed from the leg cuffs.
1. Set the pressure control to the highest level.
2. Switch off the device by pressing the On / Off button. The control lamp goes out.
3. Unplug the air-tube connection plug from the top socket on the control unit.

Cleaning and Care

CAUTION!
Keep the device in a place which is protected from direct sunlight and extreme
temperature  uctuations.
Do not use any caustic or abrasive cleaning agents to clean the device. These could
damage the device.
Before cleaning, always remove the air tubes from the leg cuffs and from the control
unit. The leg cuffs can be cleaned with a slightly damp cloth and some household
4. Now connect the plug for the air tubes to the
connection on the side of the control unit.
5. Switch on the device by pressing the On / Off but-
ton. The On / Off control lamp lights up as soon
as the device is turned on. The air is now pumped
out of the leg cuffs.
6. Once the air has been pumped out, open the zip
and remove the leg cuffs.
7. Switch off the device by pressing the On / Off but-
ton.
8. If you used the mains adapter, unplug it from both
the mains socket and the device.
35